So there you go the PF-9 hasn’t been a complete disaster like the ATI VK-22 with it’s Chiappa-sourced. In the entire time I’ve owned it, none of my shooting buddies have ever put more than one magazine through this gun at a time. This will put a quick stop to your PF-9 shooting, and don’t expect your friends to shoot it much either. And it’s got a nasty recoil that doesn’t really hurt until you notice that you’re actually bleeding.īefore you finish your third 7-shot magazine you’ll have two bleeding sores on the web of your thumb, where the grip bites you like a rattlesnake. It has a decent trigger and more accuracy than a subcompact 9mm needs, but it’s no fun for plinking tin cans or running through informal 3-Gun stages. My PF-9 is nothing but a range toy these days, and that’s a problem because it’s one of the world’s crappiest range toys. These intermittent malfunctions happened with enough frequency (a handful of FTEs in every 50 rounds) that I knew I couldn’t depend on this gun for defensive use. I never got it perfect, and the extraction problems continued. When and if the gun runs reliably, you’ll know you’ve got it perfect. You’re just supposed to tighten it, but not tighten it too tight. The extractor screw must also has to be torqued to just the perfect tightness for proper function, and this tightness is never actually specified in inch-pounds. It takes three or four hands, but I’ve only got two. All these parts have to be positioned just so before you screw down the extractor spring screw. I installed new extractors and springs, but it was a PITA: the extractor spring screw controls the tension of the extractor, and it also holds the firing pin under tension against the firing pin spring. I took advantage of Kel Tec’s excellent customer service, and they sent me lots more replacement parts. Sometimes the extractor was too stiffly sprung and wouldn’t snap over the rim of the case sometimes it was too loose and wouldn’t pull it free from the chamber after firing. Until it didn’t.Ībout 500 rounds in, the PF-9 started having feeding and ejection problems. Mostly.īut his particular malfunction probably wouldn’t have been a deal-breaker, since the PF-9 had worked fine with factory ammo. I honed the firing pin channel with fine-grit emery cloth wrapped around a cotton swab, and this eventually solved the problem. There was evidence of light primer strikes, and it took a new firing pin and a lot of elbow grease to solve this problem. As you’ll recall, the PF-9 functioned great with factory ammo but had problems digesting my standard-pressure handloads.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |